The compact DISOMAT® Tersus weighing terminal is ideal for use in a wide range of weighing applications, regardless of whether you’re focusing on operating. DISOMAT® Tersus to control a crane DISOMAT® Tersus panel-mounting unit in field housing DISOMAT® Tersus Crane Scale, see Manual BV-HAA. A Schenck model DISOMAT Tersus (VTG ) digital indicator as shown in between weighing ranges may be automatic or manual.
|Published (Last):||18 August 2009|
|PDF File Size:||20.98 Mb|
|ePub File Size:||2.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
The firmware and all individual set parameters are backed up and restored in next to no time. The module is organized as ring buffer, i. When mounting the explosion-proof protective circuitries complete with connecting parts, ensure that protection to at least IP20 is reached.
dissomat To ensure optimal EMC resistance, we recommend to use the cables indicated for the single fieldbuses. Remove separator plate, and the connector board is exposed.
If this is not the manusl, data remain stored and system outputs error message. Installing Storage Module To insert module in position XE1, push it into the receptor with arrow down inclined edge to the lower left.
Insert the three spacers into the processor board. VKG for wall-mounting To affix to the wall: Provide firmly connected power cable.
It is compatible with the previous version and also offers a range of noteworthy optimisations for ambitious planning. RS and RS can be used as alternative only 1 physical interface. If the application requires more than one serial interface, interface expansion VSS can be employed.
For details, see Operating Manual, Item 5. For further reading For further information, please refer to the documents below.
Load cells are supplied with a cycled alternating voltage. For details, see manual BV-H Office contacts Contact us.
Further information about the cookies used. If the fuse responds, you can replace it by a new one featuring the same rated data. Connect and supply the DT control terminal in the safe area as shown in wiring diagram on page When using devices tested with low impact energy, ensure that inspection window is located in a protected environment.
They can also adversely affect weighing operation. terdus
For safety hints, see Technical Data. Please note that the first and the last station on CAN bus must be equipped with a bus terminator. Other benefits at a glance: The supervisor is responsible for instructing his operators to observe all regulations and instructions given.
The table below lists the available variants: Subject to change without prior notice.
The spacers are included in the board mounting kits. Any use other than originally intended is considered inappropriate.
When replacing exchangeable fuses, always use the genuine types with same rated current. In critical locations, e.
System Manual DISOMAT_百度文库